EASY Joint PRO FAQs
Installation
It is important to carefully read and understand the mixing and application process before you start to use this product. It is not the same as our other EASYJoint products.
Yes, A light shower will not affect the application.
Troubleshooting
Any sand left on the paving surface after application will be difficult to remove and a chemical cleaner may be required, so it is important to ensure that all areas are swept and rinsed clear of as much sand as possible.
This can happen because of improper rinsing at the final stage of application. A resin cleaner will be required, although this may require more than one treatment depending on the severity of the problem. We strongly advise that paving is pre-sealed with EASYSeal Pre-Grout Protector prior to using EASYJoint PRO.
This is a natural phenomenon which is caused by a combination of temperatures and moisture levels in the atmosphere. It is quite rare and unfortunate. It is not a fault of any product. If caught early enough, it can be cleaned using soap and water. Otherwise, cleaning will require chemical/mechanical intervention. Results vary.
General
Do not use in temperatures below 5’C as low temperatures will cause damage to the epoxy activator.
This is a chemical-curing product. This means that once the two components are mixed, the curing begins. The time you have to apply the product will depend largely on the current weather conditions. Time will increase in cold weather and decrease in warmer weather.
Coverage varies according to joint and paving sizes. Please see our calculators page on our website.
EASYJoint PRO must be stored away from extreme heat and temperatures below 5’C.
Once mixed, EASYJoint PRO will start curing and this cannot be stopped. Any leftover product should be discarded as a waste product.