EASYSeal Slate & Limestone Help
Problems associated with water-based protectors are few, but the most common ones are over application and failure to remove excess. An over application will result in a patchy, uneven finish which may be slippery. It may also dry opaque and leave white lines. The remedy for this is to use EASYCare Deep Clean. Avoid this mistake by wiping the surface after application using a towel or similar cloth to remove excess.
Another reason for white marks could be that the surface was not cleaned of dust thoroughly and this has become trapped within the liquid. Again, Deep Clean will be needed to remove this.
Patchy Finish
This can occur for a few reasons including:
Un-even application
Stone temperature too high
Remains of surfactants present*
Too few coats applied
Surface of stone is almost non-permeable
Second coat applied when first has dried
Waxy / Slippery Finish
This is caused by excess protector drying on the surface. This may happen if the mstone is too hot or virtually impermeable, such as polished sandstone. The remedy for this is to use EASYCare Deep Clean. Avoid this mistake by wiping the surface after application using a towel or similar cloth to remove excess.
NOTE! Impregnating sealers are very difficult to remove! In some situations, it may not be possible to completely remove them. However, the enhancing and protecting properties generally only last around two years. In some cases, it is possible to adjust the surface appearance by using EASYCare Deep Clean and scrubbing, but this will only treat surface problems and not those that have soaked into the stone.
*Any cleaning agents which have not been thoroughly rinsed away before applying the protector.